Merge pull request #750 from JodyVanden/modify_dead_link_for_USB_flashing_section

change in tab Firmware Flasher the dead link for the USB Flashing

Author: mikeller

_locales/en/messages.json

@@ -1779,7 +1779,7 @@
         "message": "<strong>Recovery / Lost communication<strong>"
     },
     "firmwareFlasherRecoveryText": {
-        "message": "If you have lost communication with your board follow these steps to restore communication: <ul><li>Power off</li><li>Enable 'No reboot sequence', enable 'Full chip erase'.</li><li>Jumper the BOOT pins or hold BOOT button.</li><li>Power on (activity LED will NOT flash if done correctly).</li><li>Install all STM32 drivers and Zadig if required (see <a href=\"https://github.com/Betaflight/Betaflight/blob/master/docs/USB%20Flashing.md\"target=\"_blank\">USB Flashing</a> section of Betaflight manual).</li><li>Close configurator, Close all running chrome instances, Close all Chrome apps, Restart Configurator.</li><li>Release BOOT button if your FC has one.</li><li>Flash with correct firmware (using manual baud rate if specified in your FC's manual).</li><li>Power off.</li><li>Remove BOOT jumper.</li><li>Power on (activity LED should flash).</li><li>Connect normally.</li></ul>"
+        "message": "If you have lost communication with your board follow these steps to restore communication: <ul><li>Power off</li><li>Enable 'No reboot sequence', enable 'Full chip erase'.</li><li>Jumper the BOOT pins or hold BOOT button.</li><li>Power on (activity LED will NOT flash if done correctly).</li><li>Install all STM32 drivers and Zadig if required (see <a href=\"https://github.com/betaflight/betaflight/wiki/Installing-Betaflight\"target=\"_blank\">USB Flashing</a> section of Betaflight manual).</li><li>Close configurator, Close all running chrome instances, Close all Chrome apps, Restart Configurator.</li><li>Release BOOT button if your FC has one.</li><li>Flash with correct firmware (using manual baud rate if specified in your FC's manual).</li><li>Power off.</li><li>Remove BOOT jumper.</li><li>Power on (activity LED should flash).</li><li>Connect normally.</li></ul>"
     },
     "firmwareFlasherButtonLeave": {
         "message": "Leave Firmware Flasher"