##Upload To upload to the board using the FTDI adaptor:

• Reset the board by touching the blue wire on the FTDI driver to ground on the FTDI driver (where the black and white wires are soldered to)
• unplug the USB from your computer, wait 3 seconds
• replug the USB back into your computer, wait 5 seconds
• upload your code from the Arduino IDE

##Misc Notes

• 230,000 - baud rate for fast programming

• no spaces in wifi network name

##Notes on test modules*

###Controller side 1 - this is the one i resoldered the signal yellow cable, that came off 2 - upload not working, and converted #1 was getting very hot when connected to this one 3 - this is the one that works that has the latest software on it

###Converter Side 1 - getting VERY HOT to the touch, but only when connected to controller #2 2 - this one i removed the 5v converter from, and am feeding it 5v directly from the power supply